Cisco+lab+162 ((top)) Jun 2026

Tip: Lab 1.6.2 often asks you to manually set the Link-Local address to fe80::1 to make troubleshooting easier. Step 2: Implementing EUI-64

Run show interfaces trunk . You should see the ports listed with Native VLAN "1" and allowed VLANs "10,20". If this output is blank, the trunk did not form—check for mismatched encapsulation or cabling. cisco+lab+162

interface gigabitethernet 0/0/0 description Link to Network A ip address ipv6 address no shutdown exit copy running-config startup-config . 4. Verification and Troubleshooting Tip: Lab 1

From PC1, attempt to ping PC2.

This article serves as a deep dive into the objectives, topology, and configuration steps typically found within such a lab, designed to bolster your practical skills and prepare you for certification exams. What is Cisco Lab 162? If this output is blank, the trunk did